Toolox 40

MainTooloxToolox 40

Toolox ® 40

Go to order or inquire
ORDER A CONSULTATIONGET THE FULL PRICE LIST

Specifications Toolox 40

Version ENG
General description of productsMechanical propertiesImpact viscosityTolerancesRecommendations and instructionsHigh-strength engineering tool steel

General description of products Toolox 40

Pre-hardened, exceptionally pure engineering and tool steel.

Toolox® 40 is a pre-hardened steel suitable for engineering components and molds. It has good dimensional stability after machining.

Toolox® 40 has the same machinability as conventional steel P20/W.Nr 1.2311 despite its almost 100 HBW higher nominal hardness combined with the known high dimensional stability of Toolox®. This makes Toolox® 40 your ideal choice for engineering components that require greater strength, or for molds and dies that require greater wear resistance.

Size range

Toolox® 40 is available in the form of plates from 6.0 to 130.0 mm thick. Other sizes may be available upon request.

Open

Mechanical properties

THICKNESS
(mm )		 HARDNESS 1)
(HBW )
6,0 – 130,0 360 – 420

1) Hardness is measured according to EN ISO 6506-1 on the milled surface 0.5-2 mm below the plate surface.

Impact viscosity

THICKNESS
(mm )		 MINIMUM IMPACT ENERGY FOR TRANSVERSE TESTING,
TEST SAMPLE SHARPIE V 10X10 MM1)
6,0 – 130,0 20 Дж / 20 °C

1) Impact test according to EN 10 025, EN ISO 148 with a 2 mm punch.

Ultrasonic control

Ultrasonic control is carried out according to: EN 10 160 with additional requirements according to the SSAB V6 specification.

Tolerances Toolox 40

Additional information can be found in SSAB’s Toolox® Guarantees brochure and at www.toolox.com.

Open

Thickness

Tolerances as per Toolox® thickness guarantee.

Toolox® Guarantees meet the requirements of EN 10029 Class C, but offer tighter tolerances.

Length and width

Tolerances according to EN 10029.

flatness

Tolerances conform to Toolox® flatness guarantees, which are more restrictive than EN 10029, Class N (Type L steel).

Surface properties

According to EN 10163-2, class B, subclass 3.

Recommendations and instructions

Toolox® in engineering applications

Open

Processing recommendations for Toolox®

Open

Used for

  • Tools and Engineering
  • High temperatures (up to 590°C)

Available standard

  • EN 10029

High-strength engineering tool steel

New generation tool steel.

Go to Toolox
Toolox 44
Go to order

Hardox®, Armox®, Ramor®, Strenx®, Toolox®, Domex®, Duroxite® and SSAB Boron are registered trademarks of SSAB. Hard Steel Industry is an independent supplier of steel in these grades and is not an official SSAB dealer.