Toolox 33

MainTooloxToolox 33

Toolox ® 33

Go to order or inquire
ORDER A CONSULTATIONGET THE FULL PRICE LIST

Specifications Toolox 33

Version ENG
Version RU
General description of productsMechanical propertiesImpact viscosityTolerancesRecommendations and instructionsHigh-strength engineering tool steel

General description of products Toolox 33

Pre-hardened, exceptionally pure tool and engineering steel.

Due to its low carbon and alloy content, Toolox® 33 is ideal for welding as well as hot cutting. Providing the opportunity to make product components more cost-effective by saving processing time.

Supplied in hardened and tempered condition, Toolox 33 has high impact toughness and very low residual stresses to achieve good dimensional stability after machining. Toolox® 33 is suitable for molds and dies, as well as for tools and engineering components. By using proper surface treatment techniques, you can significantly extend the life of your tools and components.

Size range

Toolox® 33 is available in the form of plates from 6.0 to 130.0 mm thick. Other sizes may be available upon request.

Open

Mechanical properties

THICKNESS
(mm )		 HARDNESS 1)
(HBW )		 YIELD LIMIT R P0.2
(ХВ . MPa)		 BREAKING STRENGTH R M
(XV . MPa)		 EXTENSION A 5
(MIN .%)
6,0 – 130,0 275 – 325 700 800 10

1) Hardness is measured according to EN ISO 6506-1 on the milled surface 0.5-2 mm below the plate surface.

Impact viscosity

THICKNESS
(mm )		 MINIMUM IMPACT ENERGY FOR TRANSVERSE TESTING,
TEST SAMPLE SHARPIE V 10X10 MM1)
6,0 – 130,0 35 Дж / 20 °C

1) Unless otherwise agreed, the transverse impact test according to EN 10025-6 option 30 will apply. For thicknesses from 6 to 11.9 mm, V-shaped undersized Sharpie samples are used. Then the specified minimum value is proportional to the cross-sectional area of the sample compared to the full-size sample (10 x 10 mm).

Ultrasonic control

Ultrasonic control is carried out according to: EN 10 160 with additional requirements according to the SSAB V6 specification.

Tolerances Toolox 33

Additional information can be found in SSAB’s Toolox® Guarantees brochure and at www.toolox.com.

Open

Thickness

Tolerances as per Toolox® thickness guarantee.

Toolox® Guarantees meet the requirements of EN 10029 Class C, but offer tighter tolerances.

Length and width

Tolerances according to EN 10029.

flatness

Tolerances conform to Toolox® flatness guarantees, which are more restrictive than EN 10029, Class N (Type L steel).

Surface properties

According to EN 10163-2, class B, subclass 3.

Recommendations and instructions

Toolox® in engineering applications

Open

Processing recommendations for Toolox®

Open

Used for

  • Tools and Engineering
  • High temperatures (up to590°C)

Available standard

  • EN 10029

High-strength engineering tool steel

New generation tool steel.

Go to Toolox
Toolox 40
Go to order

Hardox®, Armox®, Ramor®, Strenx®, Toolox®, Domex®, Duroxite® and SSAB Boron are registered trademarks of SSAB. Hard Steel Industry is an independent supplier of steel in these grades and is not an official SSAB dealer.